Installation Procedure

2008 Chevrolet Chevy Express G3500, Van Passenger ExtendedSECTION Installation Procedure
WARNING: This page is about a different car, the 2008 Chevrolet Malibu Classic. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the guides to the sunshade panel. The spring feature should face upward.
  2. Fig 1: Identifying Sunroof Sunshade Panel
    GM1222461Courtesy of GENERAL MOTORS CORP.
  3. Push the sunshade guides onto the sunshade panel until fully seated.
  4. Install the sunshade panel. Refer to Sunroof Sunshade ReplacementΒ .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.