Removal Procedure

2008 Chevrolet Chevy Express G3500, Van Passenger ExtendedSECTION Removal Procedure
WARNING: This page is about a different car, the 2008 Chevrolet Malibu Classic. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Radiator Inlet Hose & Radiator
    GM1203453Courtesy of GENERAL MOTORS CORP.
  1. Drain the coolant. Refer to Cooling System Draining and Filling (L61)Β .
  2. Remove the right headlamp. Refer to Headlamp Assembly or Headlamp Bulb and/or Cornering, Sidemarker, Park, Turn Signal Bulb Replacement .
  3. Reposition the radiator inlet hose clamp at the radiator using the J 38185Β  . See Special ToolsΒ .
  4. Remove the radiator inlet hose from the radiator.
  5. Reposition the radiator inlet hose clamp at the engine using the J 38185Β  . See Special ToolsΒ .
  6. Remove the radiator inlet hose at the engine.
  7. Remove the radiator inlet hose clamps from the radiator inlet hose.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.