SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G3500, VAN PASSENGER EXTENDEDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 114 (BATTERY, CHARGING SYSTEM AND STARTING SYSTEM)REPAIR INSTRUCTIONSBATTERY NEGATIVE CABLE REPLACEMENT (LZ4)REMOVAL PROCEDURE
2008 Chevrolet Chevy Express G3500, Van Passenger Extended

Removal Procedure

2008 Chevrolet Chevy Express G3500, Van Passenger ExtendedSECTION Removal Procedure
WARNING: This page is about a different car, the 2008 Chevrolet Malibu Classic. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Battery Positive Cable, Cable Clips, Bolts & Nuts
    GM1783030Courtesy of GENERAL MOTORS CORP.
  1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
  2. Remove the negative battery cable ground terminal nut (1) from the tie bar stud.
  3. Remove the negative battery cable ground terminal (2) from the tie bar stud.
  4. Remove the negative battery cable clip (4) from the battery tray.
    5. Fig 2: Identifying Engine Wiring Harness Ground, Negative Battery Cable Ground & Nut
    GM1775665Courtesy of GENERAL MOTORS CORP.
  5. Remove the tape holding the negative battery cable to the positive battery cable.
  6. Remove the engine wiring harness nut (3).
  7. Remove the engine wiring harness terminal (2) from the transaxle stud.
  8. Remove the negative battery cable terminal (1) from the transaxle stud.
  9. Remove the negative battery cable.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.