Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G3500, VAN PASSENGER EXTENDEDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 111 (CELLULAR SYSTEM, ENTERTAINMENT SYSTEM, AND NAVIGATION SYSTEM)DIAGNOSTIC INFORMATION AND PROCEDURESONSTAR GLOBAL POSITIONING SYSTEM (GPS) DATA NOT CURRENT OR INACCURATECIRCUIT/SYSTEM VERIFICATION
2008 Chevrolet Chevy Express G3500, Van Passenger Extended
Circuit/System Verification
2008 Chevrolet Chevy Express G3500, Van Passenger ExtendedSECTION Circuit/System Verification
WARNING: This page is about a different car, the 2008 Chevrolet Malibu Classic. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
It is important to have the vehicle in an open outside area where a cellular call can be successfully placed and GPS data can be received from the satellites. It is also necessary to inform the OnStar® Call Center advisor that this call is for vehicle diagnostic purposes.
- Ignition ON, with a scan tool, observe the GPS signal status indicator for at least 10 seconds. The indicator should display Yes.
- If the indicator does not display Yes, refer to Circuit/System Testing.
- Call and verify the OnStar advisor has received the GPS data.
- If the advisor did not receive the GPS data and the call was a 'fail to voice', contact the GM Technical Assistance Center.
- If the advisor did not receive the GPS data and the call was not a 'fail to voice", refer to Circuit/System Testing.
- Verify with the OnStar Call Center advisor that your actual position is within a reasonable distance from the actual location of the vehicle.
- If your actual position is not within a reasonable distance from the actual location of the vehicle, replace the VCIM.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.