SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G3500, VAN PASSENGER EXTENDEDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 107 (INSTRUMENT PANEL TRIM AND CONSOLE TRIM)REPAIR INSTRUCTIONSCONSOLE REPLACEMENTREMOVAL PROCEDURE
2008 Chevrolet Chevy Express G3500, Van Passenger Extended

Removal Procedure

2008 Chevrolet Chevy Express G3500, Van Passenger ExtendedSECTION Removal Procedure
WARNING: This page is about a different car, the 2008 Chevrolet Malibu Classic. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the right console trim panel. Refer to Front Floor Console Side Trim Panel Replacement - Right Side .
  2. Remove the left console trim panel. Refer to Front Floor Console Side Trim Panel Replacement - Left Side .
    3. Fig 1: View Of Front Console Screws
    GM1207902Courtesy of GENERAL MOTORS CORP.
  3. Remove the front console screw covers from behind the console.
  4. Remove the front console screws.
    5. Fig 2: View Of Rear Console Bolts
    GM1207907Courtesy of GENERAL MOTORS CORP.
  5. Position the front seats to the full forward position.
  6. Remove the rear console bolts.
  7. Place the shifter in drive.
    8. Fig 3: View Of Pen Tray
    GM1207906Courtesy of GENERAL MOTORS CORP.
  8. Remove the pen tray.
    9. Fig 4: View Of Electrical Connectors And Console
    GM1207909Courtesy of GENERAL MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.