SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G3500, VAN PASSENGER EXTENDEDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1000 (WIRING SYSTEMS AND POWER MANAGEMENT - A/C COMPRESSOR CLUTCH THROUGH GENERATOR X2)DOOR CONTROL MODULE - DRIVER X4
2008 Chevrolet Chevy Express G3500, Van Passenger Extended

Door Control Module - Driver X4

2008 Chevrolet Chevy Express G3500, Van Passenger ExtendedSECTION Door Control Module - Driver X4
WARNING: This page is about a different car, the 2009 Cadillac STS. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Door Control Module - Driver X4 Connector End View
GM1549444Courtesy of GENERAL MOTORS CORP.
Door Control Module - Driver X4

Pin Wire Circuit Function
1 0.35 L-GN 89 Left Mirror Motor Down Control
2 0.35 YE 88 Left Mirror Motor Up Control
3 0.35 YE 190 Left Folding Mirror Motor Extend Control (DL7)
4 0.35 L-BU 191 Left Folding Mirror Motor Retract Control (DL7)
5 0.35 L-BU 82 Left Mirror Motor Left Control
6 0.35 BK 606 Left Mirror Heating Element Supply Voltage
7 0.35 GY 5855 LED Signal (UFT)
8 0.35 BK 627 Left Mirror Heating Element Low Reference
Connector Part Information 
  • OEM: 175964-2
  • Service: 15306185
  • Description: 8-Way F AMP Multi-Lock 040 Series Mark II (BK)
Terminal Part Information 
  • Terminal/Tray: See Terminal Repair Kit
  • Core/Insulation Crimp: See Terminal Repair Kit
  • Release Tool/Test Probe: See Terminal Repair Kit
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.