Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Circuit/System Description
The driver information switches are normally open momentary switches. Power is provided to the driver information center (DIC) switches via the instrument panel cluster (IPC). The IPC interfaces with the DIC switches via 3 discreet circuits. The switch input to the cluster is pulled low or grounded when a switch is activated. The IPC reads the voltage at the analog input to determine which switch(es) is pressed. The switch input to the cluster is set up in a resistor ladder format for three of the four switches. The DIC switches include the MENU, SET/RESET, TRIP/FUEL, AND VEHICLE INFORMATION switches. A stuck switch or a short to battery sets a DTC.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.