Front Axle Lubricant Level Inspection

2008 Chevrolet Chevy Express G3500, Van Passenger ExtendedSECTION Front Axle Lubricant Level Inspection
  1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Inspect the front axle for leaks. Repair as necessary.
  3. Clean the area around the front axle fill plug.
  4. Fig 1: Front Axle Fill Plug
    GM1199445Courtesy of GENERAL MOTORS CORP.
  5. Remove the fill plug.
  6. Inspect the oil level.

    Specification:Β  The oil level should be between 0-10 mm (0-0.38 in) below the bottom of the fill plug opening.

  7. If the level is low, add oil until the level is even with the bottom of the edge of the fill plug opening. Use the proper fluid. Refer to Fluid and Lubricant Recommendations .
  8. NOTE: Refer to Fastener Notice .
  9. Install the fill plug.

    Tighten:Β  Tighten the fill plug to 33 N.m (24 lb ft).

  10. Lower the vehicle.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.