Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G3500, VAN PASSENGER EXTENDEDREPAIR AND DIAGNOSISBODY & FRAMEWINDOWSFIXED & MOVEABLE WINDOW SYSTEMSREPAIR INSTRUCTIONSFRONT SIDE DOOR WINDOW REPLACEMENTREMOVAL PROCEDURE
2008 Chevrolet Chevy Express G3500, Van Passenger Extended
Removal Procedure
2008 Chevrolet Chevy Express G3500, Van Passenger ExtendedSECTION Removal Procedure
- Raise the front door window (1) approximately half way in order to access the nuts (2) that retain the front door window to the sash.
- Remove the front door trim panel. Refer to Front Side Door Trim Panel Replacement .
- Remove the front door rear garnish. Refer to Front Side Door Rear Garnish Molding Replacement .
- Remove the front door water deflector. Refer to Front Side Door Water Deflector Replacement .
- Lower the front door window (1).
- Remove the inner window sealing strip. Refer to Front Side Door Window Belt Inner Sealing Strip Replacement .
- Remove the outer window sealing strip. Refer to Outer Belt Sealing Strip Replacement .
- Remove the front run channel from the door. Refer to Window Channel Replacement .
- Remove the nuts (2) that retain the front door window (1) to the sash.
- Remove the front door window (1) from the door from the outer side of the vehicle.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.