Removal Procedure

2008 Chevrolet Chevy Express G3500, Van Passenger ExtendedSECTION Removal Procedure
CAUTION: When working with any type of glass or sheet metal with exposed or rough edges, wear approved safety glasses and gloves in order to reduce the chance of personal injury.
    Fig 1: Aligning Mirror Face Retention Clips With Adjuster Mechanism (DL3, DR4, DL8, 5M1)
    GM625764Courtesy of GENERAL MOTORS CORP.
  1. Remove the damaged mirror back and the glass-assembly from the mirror housing by completing the following steps:
    1. Insert your fingers as far as possible behind the mirror back toward the center of the back.
    2. With force sufficient in order to disengage the snap-fits from the adjuster mechanism, pull the mirror back out of the housing.
  2. Inspect the adjuster mechanism for damage.
  3. If the mirror has the heated feature, unplug the 2 electrical connections from the mirror back.
  4. Remove the mirror face from the mirror housing.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.