Windshield Washer Solvent Container Replacement

2008 Chevrolet Chevy Express G3500, Van Passenger ExtendedSECTION Windshield Washer Solvent Container Replacement
Fig 1: Windshield Washer Solvent Container
GM1892814Courtesy of GENERAL MOTORS CORP.
Callout Component Name

Preliminary Procedure

  1. Open and support the hood.
  2. Place a clean container under the work area prior to removing the windshield washer pump hose from the pump.
1 Front End Panel Bolt
NOTE: Refer to Fastener Notice .

Tighten:Β  10 N.m (89 lb in)

2 Windshield Washer Front End Panel Nut
3 Windshield Washer Pump Electrical Connector
Tip:Β  Disconnect the electrical connector and position out of the way.
4 Windshield Washer Pump Hose
5 Windshield Washer Solvent Container
Tip:Β  Lift the container from the locating holes in the front end lower panel support.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.