Removal Procedure

2008 Chevrolet Chevy Express G3500, Van Passenger ExtendedSECTION Removal Procedure
  1. Remove the instrument cluster panel. Refer to Instrument Panel Cluster Trim Plate Bezel Replacement .
  2. Fig 1: Radio & Support Bracket Screws
    GM665518Courtesy of GENERAL MOTORS CORP.
  3. Remove the screws (2) that secure the radio to the support bracket (1).
  4. Remove the radio from the support bracket enough to access the connectors at rear of the radio.
  5. Disconnect the electrical/audio and antenna cable connectors from the radio.
  6. Remove the radio.
  7. Fig 2: Radio Mounting Bracket & Instrument Panel Carrier Screws
    GM639268Courtesy of GENERAL MOTORS CORP.
  8. If removing the radio mounting bracket. Perform the following steps:
    1. Detach the clip retaining the HVAC harness to the radio mounting bracket.
    2. Remove the screws (2) retaining the radio mounting bracket (1) to the instrument panel carrier.
    3. Remove the radio mounting bracket from the vehicle.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.