Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G2500, VAN CARGO, 6.6 6REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 947 (POWER SEAT SYSTEM)DIAGNOSTIC INFORMATION AND PROCEDURESPOWER SEAT INOPERATIVE (W/MEMORY)CIRCUIT/SYSTEM VERIFICATION
2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6
Circuit/System Verification
2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6SECTION Circuit/System Verification
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
- Install a scan tool and display the MSM switch inputs.
- Verify that none of the switches are displayed as Active while in an inactive state.
- If any of the switch inputs are Active, perform the affected Switch Circuit Test.
- Verify that the switch inputs are displayed as Active while the switch is pressed.
- If any of the switch inputs remain Inactive while the switch is pressed, perform the affected Switch Circuit Test.
- If the switch inputs to the MSM function normal, perform the Motor Control Circuit Test.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.