SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G2500, VAN CARGO, 6.6 6REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 945 (HVAC SYSTEM - AUTOMATIC)REPAIR INSTRUCTIONSINSIDE AIR TEMPERATURE SENSOR ASSEMBLY REPLACEMENT - AUXILIARYINSTALLATION PROCEDURE
2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6

Installation Procedure

2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6SECTION Installation Procedure
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the new sensor grille to the headliner.
    2. Fig 1: View Of Inside Air Temperature Sensor
    GM675994Courtesy of GENERAL MOTORS CORP.
  2. Install the inside air temperature sensor to the headliner and sensor grille.
    3. Fig 2: View Of Inside Air Temperature Sensor Electrical Connector
    GM675996Courtesy of GENERAL MOTORS CORP.
  3. Connect the electrical connector to the inside air temperature sensor.
  4. Secure the headliner to the roof Velcro.
  5. Install the rear headliner retainers to the front headliner.
  6. Install the left rear coat hook, if equipped. Refer to Coat Hook Replacement .
  7. Install the third pillar molding. Refer to Garnish Molding Replacement - Center Pillar Upper .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.