SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G2500, VAN CARGO, 6.6 6REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 940 (FRONT SUSPENSION SYSTEM)REPAIR INSTRUCTIONSLOWER CONTROL ARM REPLACEMENT (1500 SERIES)REMOVAL PROCEDURE
2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6

Removal Procedure

2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6SECTION Removal Procedure
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT: The lower ball joint and control arm are serviced as an assembly and are not serviced separately.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Support the lower control arm with a safety stand.
  3. Remove the tire and wheel. Refer to Tire and Wheel Removal and Installation .
  4. Remove the stabilizer shaft links from the lower control arm. Refer to Stabilizer Shaft Link Replacement (1500 Series)  or Stabilizer Shaft Link Replacement (2500 Series) .
    5. Fig 1: View Of Lower Shock Absorber Module Mount Bolts
    GM1761077Courtesy of GENERAL MOTORS CORP.
  5. Remove the 2 lower shock absorber module mount bolts.
  6. If equipped, remove the wheel drive shaft nut.
    7. Fig 2: View Of Lower Ball Joint Retaining Nut
    GM1761079Courtesy of GENERAL MOTORS CORP.
  7. Remove the lower ball joint retaining nut.
    8. Fig 3: Separating The Lower Ball Joint From The Steering Knuckle (RWD)
    GM853943Courtesy of GENERAL MOTORS CORP.
  8. Using the J 43631  and the J 45851  , remove the lower ball joint from the steering knuckle. See Special Tools .
  9. Remove the lower control arm nuts and washers.
  10. Remove the control arm bolts.
  11. Remove the control arm.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.