Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G2500, VAN CARGO, 6.6 6REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 920 (MIRROR SYSTEM)REPAIR INSTRUCTIONSMOTOR REPLACEMENT - POWER MIRROR

2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6

Motor Replacement - Power Mirror

2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6SECTION Motor Replacement - Power Mirror

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Outside Rearview Mirror Motor & Components

Courtesy of GENERAL MOTORS CORP.

Motor Replacement - Power Mirror

Callout	Component Name
1	Outside Rearview Mirror Face Tip: Tip the mirror face outward at the bottom. With a twisting motion push upward on the bottom of the mirror face and pull rearward until it releases from the rearview mirror motor. Disconnect the electrical connectors.
2	Outside Rearview Mirror Motor Screws (Qty: 4) NOTE: Refer to Fastener Notice . Tighten: 2 N.m (18 lb in)
3	Outside Rearview Mirror Motor Tip: Gently press the mirror back into the adjuster mechanism with the palm of the hand on the center of the glass until it locks into place.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.