Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G2500, VAN CARGO, 6.6 6REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 919 (BATTERY, CHARGING SYSTEM AND STARTING SYSTEM)DIAGNOSTIC INFORMATION AND PROCEDURESSCAN TOOL OUTPUT CONTROLS
2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6
Scan Tool Output Controls
2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6SECTION Scan Tool Output Controls
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Engine Control Module (ECM)
| Scan Tool Output Control | Additional Menu Selection(s) | Description |
|---|---|---|
| GEN L-Terminal | Engine Control Module, Special Functions | Commands the generator L terminal On and Off. |
| Starter Relay | Engine Control Module, Special Functions | Commands the starter relay On and Off. |
Instrument Panel Cluster (IPC)
| Scan Tool Output Control | Additional Menu Selection(s) | Description |
|---|---|---|
| Segment Check | Instrument Panel Cluster, Special Functions | The IPC illuminates all indicators for 7 seconds. |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.