Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G2500, VAN CARGO, 6.6 6REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 918 (ENGINE CONTROL SYSTEM & FUEL - 4.8L, 5.3L, 6.0L AND 6.2L - INTRODUCTION (2 OF 2))REPAIR INSTRUCTIONSACCELERATOR PEDAL POSITION SENSOR REPLACEMENTREMOVAL PROCEDURE

2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6

Removal Procedure

2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6SECTION Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Handle the electronic throttle control components carefully. Use cleanliness in order to prevent damage. Do not drop the electronic throttle control components. Do not roughly handle the electronic throttle control components. Do not immerse the electronic throttle control components in cleaning solvents of any type.

Fig 1: View Of APP Sensor Electrical Connector

Courtesy of GENERAL MOTORS CORP.

Remove the knee bolster. Refer to Knee Bolster Replacement (Cadillac) or Knee Bolster Replacement (Except Cadillac) .
Push down the small tab and disconnect the accelerator pedal position (APP) sensor electrical connector (1).

Fig 2: View Of Accelerator Pedal Position Sensor Assembly

Courtesy of GENERAL MOTORS CORP.

Remove the accelerator pedal bolts.
Remove the accelerator pedal.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.