Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G2500, VAN CARGO, 6.6 6REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 845 (HYBRID CONTROL SYSTEM)COMPONENT LOCATORHYBRID CONTROLS COMPONENT VIEWS
2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6
Hybrid Controls Component Views
2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6SECTION Hybrid Controls Component Views
WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
| Callout | Component Name |
|---|---|
| 1 | Starter Generator Control Module (GCM) |
| 2 | Automatic Transmission Pump - Auxiliary |
| 3 | Starter Generator Control Module (GCM) Connectors |
| 4 | Starter Generator Control Module (GCM) Bracket |
| 5 | Hybrid Pump Driver |
| 6 | Starter Generator Control Module (GCM) Coolant Pump |
| 7 | Starter Generator |
| Callout | Component Name |
|---|---|
| 1 | Powertrain Control Module (PCM) |
| 2 | Transmission Control Module (TCM) |
| 3 | Crankshaft Position (CKP) Sensor |
| 4 | Engine Oil Pressure (EOP) Switch |
| 5 | Knock Sensor |
| 6 | Starter |
| 7 | A/C Compressor Clutch |
| 8 | Starter Generator |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.