Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G2500, VAN CARGO, 6.6 6REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 837 (ENGINE CONTROLS AND FUEL - 2.2L (L61) - INTRODUCTION (2 OF 2))COMPONENT LOCATORENGINE CONTROLS COMPONENT VIEWS
2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6
Engine Controls Component Views
2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6SECTION Engine Controls Component Views
WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
| Callout | Component Name |
|---|---|
| 1 | Mass Air Flow (MAF) Sensor |
| 2 | Camshaft Position (CMP) Actuator Solenoid - Intake |
| 3 | Camshaft Position (CMP) Actuator Solenoid - Exhaust |
| 4 | Ignition Coil Module 1 |
| 5 | Ignition Coil Module 2 |
| 6 | Ignition Coil Module 3 |
| 7 | Ignition Coil Module 4 |
| 8 | Throttle Actuator Control (TAC) Module |
| 9 | Fuel Injector 4 |
| 10 | Fuel Injector 3 |
| 11 | Fuel Injector 2 |
| 12 | Fuel Injector 1 |
| Callout | Component Name |
|---|---|
| 1 | Spark Plugs |
| 2 | Manifold Absolute Pressure (MAP) Sensor |
| 3 | Knock Sensor (KS) |
| 4 | Crankshaft Position (CKP) Sensor |
| 5 | Engine Oil Pressure (EOP) Switch |
| 6 | Generator Mounting Location |
| 7 | A/C Compressor Clutch Location |
| 8 | Heated Oxygen Sensor (HO2S) Sensor 1 |
| 9 | Engine Coolant Temperature (ECT) Sensor |
| Callout | Component Name |
|---|---|
| 1 | Evaporative Emissions (EVAP) Canister Purge Solenoid |
| 2 | Vehicle Speed Sensor (VSS) |
| 3 | Heated Oxygen Sensor (HO2S) 2 |
| 4 | Heated Oxygen Sensor (HO2S) 1 |
| 5 | Park/Neutral Position (PNP) Switch |
| 6 | Engine Coolant Temperature (ECT) Sensor |
| 7 | G107 |
| Callout | Component Name |
|---|---|
| 1 | Wheel Well - RR |
| 2 | Fuel Tank Pressure (FTP) Sensor |
| 3 | Fuel Pump and Sender Assembly - Primary |
| 4 | Fuel Tank |
| 5 | Fuel Pump and Sender Assembly - Secondary |
| 6 | Evaporative Emissions (EVAP) Canister Vent Solenoid |
| Callout | Component Name |
|---|---|
| 1 | Transmission - 4T45-E |
| 2 | Vehicle Speed Sensor (VSS) |
| 3 | Park Neutral Position (PNP) Switch |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.