Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G2500, VAN CARGO, 6.6 6REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 700 (FRONT DRIVE AXLE)REPAIR INSTRUCTIONSINNER AXLE SEAL AND/OR BEARING REPLACEMENT - FRONT DRIVE AXLENOTES
2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6
Inner Axle Seal and/or Bearing Replacement - Front Drive Axle: Notes
2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6SECTION Notes
WARNING: This page is about a different car, the 2006 GMC Sierra, 2006 GMC Cab & Chassis Sierra, 2006 Chevrolet Silverado, and 2006 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
Tools Required
- J 8092 Universal Driver Handle - 3/4 in - 10. See Special Tools .
- J 2619-01 Slide Hammer
- J 29369-1 Bushing and Bearing Remover. See Special Tools .
- J 29369-2 Bushing and Bearing Remover (2-3 inch). See Special Tools .
- J 36609 Axle Tube Bearing Installer. See Special Tools .
- J 45225 Axle Seal Installer. See Special Tools .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.