Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G2500, VAN CARGO, 6.6 6REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 690 (BODY FRONT END)REPAIR INSTRUCTIONSHOOD LATCH REPLACEMENTINSTALLATION PROCEDURE

2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6

Installation Procedure

2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6SECTION Installation Procedure

WARNING: This page is about a different car, the 2006 GMC Sierra and 2006 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Connect the hood release cable end to the latch.

Fig 1: Installing Hood Release Cable To Latch
Courtesy of GENERAL MOTORS CORP.
Connect the hood ajar indicator switch connector, if equipped.
Install the hood latch (1) to the radiator support (3).

Fig 2: Installing Hood Latch To Radiator Support
Courtesy of GENERAL MOTORS CORP.
Install the hood latch bolts (2) loosely.
Adjust the hood latch height so that when the hood is closed, the hood is held securely against the front hood bumpers.

NOTE: Refer to Fastener Notice .

Raise the hood.
Tighten: Tighten the hood latch bolts to 9 N.m (80 lb in).
Adjust the front hood bumpers so that the top of the hood is flush with the fenders.
Install the upper radiator support baffle. Refer to Radiator Air Baffle and Deflector Replacement - Upper .

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.