SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G2500, VAN CARGO, 6.6 6REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 674 (CRUISE CONTROL SYSTEM)REPAIR INSTRUCTIONSCRUISE CONTROL CABLE REPLACEMENT (4.3L ENGINE)REMOVAL PROCEDURE
2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6

Removal Procedure

2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6SECTION Removal Procedure
WARNING: This page is about a different car, the 2006 GMC Sierra and 2006 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT: The cruise control cable does not require mechanical adjusting after replacement. The cruise control module internally adjusts the cable. Refer to Cruise Control Description and Operation (4.3L)  or Cruise Control Description and Operation (4.8L, 5.3L, 6.0L, and 8.1L)  for the complete operational details.
  1. Disconnect the cruise control cable locator clip from the outboard rectangular hole in the routing bracket at the left front corner of the engine.
    Fig 1: Disconnecting Cruise Control Cable Locator Clip
    GM600834Courtesy of GENERAL MOTORS CORP.
  2. Disconnect the cruise control cable conduit fitting from the round hole in the engine cable bracket.
  3. Disconnect the cruise control cable engine-end fitting from the stud on the throttle lever.
  4. Disconnect the cruise control cable fitting from the cruise control module.
  5. Disconnect the cruise control cable bead from the fitting on the cruise control module ribbon.
    Fig 2: Disconnecting Cruise Control Cable Bead From Cruise Control Module
    GM373548Courtesy of GENERAL MOTORS CORP.
  6. Remove the cruise control cable from the vehicle.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.