SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G2500, VAN CARGO, 6.6 6REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 573 (AUTOMATIC TRANSMISSION - 4L60-E/4L65-E (INTRODUCTION, SERVICE & REPLACEMENT))SPECIFICATIONSRANGE REFERENCE
2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6

Range Reference

2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6SECTION Range Reference
WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
Range Reference Table

Range Park Reverse Neutral OD D 2 1
Gear - - - 1st 2nd 3rd 4th 1st 2nd 3rd 1st** 2nd 1st 2nd***
1-2 Shift Solenoid  ON* ON* ON* ON OFF OFF ON ON OFF OFF ON OFF ON OFF
2-3 Shift Solenoid  ON* ON* ON* ON ON OFF OFF ON ON OFF ON ON ON ON
2-4 Band  - - - - A - A - A - - A - A
Reverse Input Clutch  - A - - - - - - - - - - - -
Overrun Clutch  - - - - - - - - - A A A A A
Forward Clutch  - - - A A A A A A A A A A A
Forward Sprag Clutch Assembly  - - - H H H - H H H H H H H
3-4 Clutch  - - - - - A A - - A - - - -
Lo/Roller Clutch  - - - H - - - H - - H - H -
Lo/Rev Clutch  A A - - - - - - - - - - A -
  • A = Applied
  • H = Holding
  • ON = The solenoid is energized.
  • OFF = The solenoid is de-energized.
  • *Shift Solenoid state is a function of vehicle speed and may change if the vehicle speed increases sufficiently in Park, Reverse or Neutral. However, this does not affect the operation of the transmission.
  • **Manual Second-First gear is electronically prevented under normal operating conditions.
  • ***Manual First-Second gear is only available above approximately 48-56 km/h (30-35 mph).
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.