Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G2500, VAN CARGO, 6.6 6REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 571 (SEAT BELT SYSTEM)REPAIR INSTRUCTIONSCHILD RESTRAINT TETHER ANCHOR REPLACEMENTINSTALLATION PROCEDURE

2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6

Installation Procedure

2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6SECTION Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Child Restraint Tether Anchor Plate & Bolt

Courtesy of GENERAL MOTORS CORP.

Insert the anchor plate through the slit in the carpet.
Align the anchor plate with the raised end forward.
Start the bolt through the anchor plate into the hole in the floor reinforcement.
NOTE: Refer to Fastener Notice in Cautions and Notices.

IMPORTANT: Insure the anchor plate does not turn while tightening the bolt.

Tighten the child restraint tether anchor plate bolt.
Tighten: Tighten the child restraint tether anchor plate bolt to 27 N.m (20 lb ft).
Reposition the carpet over the bolt.
Install the child restraint tether, if the child restraint is installed.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.