SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G2500, VAN CARGO, 6.6 6REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 566 (STATIONARY WINDOW SYSTEM)REPAIR INSTRUCTIONSREARVIEW MIRROR REPLACEMENT (DD8)INSTALLATION PROCEDURE
2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6

Installation Procedure

2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6SECTION Installation Procedure
WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Electrical Connector To Back Of Inside Rearview Mirror
    GM375840Courtesy of GENERAL MOTORS CORP.
  1. Install the electrical connector (1) to the back of the inside rearview mirror.
    2. Fig 2: Inside Rearview Mirror To Windshield
    GM161476Courtesy of GENERAL MOTORS CORP.
  2. Perform the following steps to install the inside rearview mirror:
    1. Center the bottom of the inside rearview mirror on the support.
      2. IMPORTANT: Do NOT pull rearward on the mirror while installing the mirror or damage to the support and/or windshield will occur.
    2. Rock the inside rearview mirror from side to side while pushing downward firmly. Take care not to damage the windshield.
    3. An audible click is heard when the inside rearview mirror is fully seated.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.