Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G2500, VAN CARGO, 6.6 6REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 555 (SEAT SYSTEM)REPAIR INSTRUCTIONSSEAT BACK TRIM REPLACEMENT - FRONTINSTALLATION PROCEDURE

2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6

Installation Procedure

2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6SECTION Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Pillow To Seat Frame

Courtesy of GENERAL MOTORS CORP.

Install the cover if removed.
Position the insert pillow to the seat back.
Zip the insert pillow upper zipper closed.

IMPORTANT: To achieve the best appearance install the insert pillow tabs under the seat back cover tabs.

Attach the insert pillow and seat back cover with fir tree fasteners.
- Slide the insert pillow tabs and the upper seat back cover tabs over the upper fir tree fastener heads and push the fasteners in to secure (design 1).
- Install the fir tree fasteners through the seat back cover tabs and the insert pillow tabs and push the fasteners into the seat back frame (design 2).
Tuck the zipper ends out of sight into the seat trim.
Fasten the lower J strips.
From the back of the seat, ensure the seat back cover is pulled down enough for the J strip at the bottom to rest entirely on the forward side of the seat frame.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.