SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G2500, VAN CARGO, 6.6 6REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 543 (LIGHTING SYSTEMS)REPAIR INSTRUCTIONSHIGH MOUNTED STOP LAMP REPLACEMENTINSTALLATION PROCEDURE
2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6

Installation Procedure

2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6SECTION Installation Procedure
WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Stop Lamp To Rear Fascia
    GM64627Courtesy of GENERAL MOTORS CORP.
  1. Install the high-mounted stop lamp into position inside the rear fascia.
  2. Loosely install the stop lamp mounting screws.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Align the stop lamp to the rear fascia, then press and hold the lamp to the fascia for flushness.

    Tighten:  Tighten the high-mounted stop lamp retaining screws to 4 N.m (35 lb in).

    4. Fig 2: Electrical Connector To Stop Lamp
    GM64626Courtesy of GENERAL MOTORS CORP.
  4. Connect the electrical connector to the stop lamp.
  5. Install the inner tail lamp. Refer to Tail Lamp Replacement .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.