Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G2500, VAN CARGO, 6.6 6REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 537 (MANUAL TRANSMISSION -- TREMEC 6-SPEED)COMPONENT LOCATORMANUAL TRANSMISSION COMPONENT VIEWS
2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6
Manual Transmission Component Views
2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6SECTION Manual Transmission Component Views
WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
| Callout | Component Name |
|---|---|
| 1 | Reverse Inhibit Solenoid |
| 2 | Skip Shift Solenoid |
| 3 | Vehicle Speed Sensor (VSS) |
| Callout | Component Name |
|---|---|
| 1 | Stop Lamp Switch C1 |
| 2 | Stop Lamp Switch C3 |
| 3 | C213 |
| 4 | Bose Signal Processor |
| 5 | Accelerator Pedal Position (APP) Sensor |
| 6 | Accelerator Pedal |
| 7 | Brake Pedal |
| 8 | Steering Wheel Position Sensor |
| 9 | Clutch Pedal |
| 10 | Clutch Pedal Start Switch |
| 11 | Clutch Pedal Position Switch |
| 12 | Stop Lamp Switch |
| 13 | Stop Lamp Switch Connector C2 |
| Callout | Component Name |
|---|---|
| 1 | Transmission Fluid Temperature (TFT) Sensor |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.