SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G2500, VAN CARGO, 6.6 6REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 536 (ANTILOCK BRAKE SYSTEM, TRACTION CONTROL SYSTEM & STABILITY CONTROL SYSTEM)DIAGNOSTIC INFORMATION AND PROCEDURESDTC C1282CONDITIONS FOR RUNNING THE DTC
2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6

Conditions for Running the DTC

2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6SECTION Conditions for Running the DTC
WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.

The EBCM performs 6 different tests to detect a DTC condition. The numbers below correspond to the numbers in Conditions for Setting the DTC.

  1. The yaw rate sensor bias test runs with the ignition ON.
  2. The yaw rate sensor acceleration test runs with the ignition ON.
  3. The yaw rate sensor circuit test runs with the vehicle stopped or with the vehicle speed greater than 45 km/h (28 mph).
  4. The yaw rate isolation test runs with the following conditions:
    • The brake pedal is not pressed.
    • The ABS is not active.
    • The vehicle speed is greater than 5 km/h (3 mph).
  5. The above yaw rate isolation test run with the VSES active.
  6. The false activation test runs with the VSES active.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.