Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G2500, VAN CARGO, 6.6 6REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 527 (SEAT SYSTEM)REPAIR INSTRUCTIONSTRIM PANEL REPLACEMENT - FRONT SEATINSTALLATION PROCEDURE

2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6

Installation Procedure

2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6SECTION Installation Procedure

WARNING: This page is about a different car, the 2003 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.

Install a new barrel clip (1) to the trim panel upper barrel post (2)

Fig 1: Installing New Barrel Clip To Trim Panel Upper Barrel Post
Courtesy of GENERAL MOTORS CORP.
Install the switch to the panel (if removed).
Connect the switch harness.

Fig 2: Switch To Panel
Courtesy of GENERAL MOTORS CORP.
Install the seat side trim panel.
- Push the barrel post with clip through the hole in the seat cover and into the hole in the seat frame.
- Install the front and rear trim panel attaching screws.
  
  Fig 3: Seat Side Trim Panel
  Courtesy of GENERAL MOTORS CORP.
Install the seat back recliner handle. Refer to SEAT BACK RECLINER HANDLE REPLACEMENT - FRONT .

Fig 4: Seat Back Recliner Handle
Courtesy of GENERAL MOTORS CORP.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.