SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G2500, VAN CARGO, 6.6 6REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 513 (WIPER SYSTEM AND WASHER SYSTEM)REPAIR INSTRUCTIONSWIPER ARM REPLACEMENTREMOVAL PROCEDURE
2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6

Removal Procedure

2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6SECTION Removal Procedure
WARNING: This page is about a different car, the 2003 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
  1. Open the hood.
  2. Turn the ignition switch to the ACCY position.
  3. Turn the wiper switch to the DELAY position.
  4. Turn the ignition switch OFF when the wiper arms are in the inner wipe position and not moving.
  5. Place a piece of masking tape (5) onto the windshield at the tip of each wiper blade (6) to aid in the wiper arm reinstallation.
  6. Disconnect the washer hose (3) from the air inlet grille panel.
  7. Remove the wiper arm nut cover (1).
  8. Remove the wiper arm nut (2).
  9. Using the J 39822, remove the wiper arm from the wiper transmission.
  10. Remove the wiper blade from the wiper arm. Refer to WIPER ARM BLADE REPLACEMENT .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.