SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G2500, VAN CARGO, 6.6 6REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 513 (WIPER SYSTEM AND WASHER SYSTEM)REPAIR INSTRUCTIONSWASHER SOLVENT CONTAINER REPLACEMENTINSTALLATION PROCEDURE
2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6

Installation Procedure

2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6SECTION Installation Procedure
WARNING: This page is about a different car, the 2003 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the washer solvent container to the vehicle.
  2. Connect the washer pump hose.
  3. Connect the washer pump electrical connector.
    Fig 1: Connecting Washer Pump Hose
    G01453435Courtesy of GENERAL MOTORS CORP.
  4. Install the washer solvent container onto the mounting studs.
  5. Install the heater hose retention clamp onto the mounting stud.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  6. Install the washer solvent container nuts.

    Tighten  Tighten the nuts to 8 N.m (71 lb in).

    Fig 2: Washer Solvent Container Nuts
    G01453436Courtesy of GENERAL MOTORS CORP.
  7. Connect the washer solvent container level sensor electrical connector.
  8. Fill the washer solvent container with washer solvent.
  9. Close the hood.
  10. Inspect the washer system for proper operation.
    Fig 3: Connecting Washer Solvent Container Level Sensor Electrical Connector
    G01453437Courtesy of GENERAL MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.