SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G2500, VAN CARGO, 6.6 6REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 51 (ENGINE CONTROLS - SYSTEM & COMPONENT TESTING - 6.6L)FUEL SYSTEMSGLOW PLUG SYSTEM DIAGNOSISDIAGNOSTIC AIDS
2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6

Diagnostic Aids

2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6SECTION Diagnostic Aids
WARNING: This page is about a different car, the 2003 GMC Sierra, 2003 GMC Cab & Chassis Sierra, 2003 Chevrolet Silverado, and 2003 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

If glow plug relay or controller is stuck in ON position, check for proper operation of the glow plugs. When glow plugs are commanded ON by scan tool, an internal ECM timer protects glow plugs from damage by cycling them ON for 3 seconds and then OFF for 12 seconds. Most glow plug system failures are covered by DTC P0380. If no DTCs are stored and the engine is hard to start, and White smoke is present during cranking or after engine is started, the most likely cause of failure is faulty glow plugs.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.