SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G2500, VAN CARGO, 6.6 6REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 502 (ANTILOCK BRAKE SYSTEM)REPAIR INSTRUCTIONSBRAKE FLUID PRESSURE SENSOR REPLACEMENTINSTALLATION PROCEDURE
2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6

Installation Procedure

2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6SECTION Installation Procedure
WARNING: This page is about a different car, the 2003 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Refer to FASTENER NOTICE .
    Fig 1: Installing Brake Fluid Pressure Sensor
    G01420476Courtesy of GENERAL MOTORS CORP.
  1. Install the brake fluid pressure sensor to the EBCM in the vehicle.

    Tighten 

    Tighten the switch to 22 N.m (16 lb ft).

  2. Connect the brake pressure sensor electrical connector.
  3. Reposition the EBCM to the support bracket and tighten the insulator nuts (1).

    Tighten 

    Tighten the nuts to 12 N.m (106 lb in).

  4. Install and connect the radiator inlet hose.
  5. Fill the cooling system. Refer to DRAINING AND FILLING COOLING SYSTEM in Engine Cooling.
  6. Perform the DIAGNOSTIC SYSTEM CHECK - ABS  .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.