Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G2500, VAN CARGO, 6.6 6REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 387 (SEAT SYSTEM)REPAIR INSTRUCTIONSARMREST REPLACEMENT - FRONT SEATINSTALLATION PROCEDURE
2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6
Installation Procedure
2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6SECTION Installation Procedure
WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
- Install the clip in the slot of the seat frame.
- Install the rubber band on the clip to retain it in place.
- Fold down the seat cover.
- Install the arm rest by pressing in until it is fully seated.
- Connect the heating element wire connector.
- Set the front seat back in the forward position.
- Pull down on the seat cover in order to install the 2 push pins retaining the seat back to the card board.
- Connect the J-clip at the bottom of the seat.
- Push on the seat back cover to ensure the cover is held in place by the velcro.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.