Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G2500, VAN CARGO, 6.6 6REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 292 (LIGHTING SYSTEM)LICENSE PLATE LIGHT REMOVAL/INSTALLATION
2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6
License Plate Light Removal/Installation
2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6SECTION License Plate Light Removal/Installation
WARNING: This page is about a different car, the 2004 Mazda 3. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect the negative battery cable.
- Remove the lens, then remove the license plate light bulb.
- Remove the license plate light from the rear bumper.
- Remove the trunk end trim. (See TRUNK END TRIM REMOVAL/INSTALLATION .)
- Remove the fasteners and slightly bend back the trunk side trim (RH).
- Remove the fasteners and slightly bend back the trunk side trim (LH). (4 door)
- Remove the service hole cover (LH). (5 door)
- Remove the rear combination light. (See REAR COMBINATION LIGHT REMOVAL/INSTALLATION .)
- Disconnect the license plate light connector.
- Remove the rear bumper. (See REAR BUMPER REMOVAL/INSTALLATION .)
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.