Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G2500, VAN CARGO, 6.6 6REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 28 (ENGINE CONTROL SYSTEM - SELF-DIAGNOSTICS)DRIVE CYCLESINSPECTION/MAINTENANCE EVAP SYSTEM SET PROCEDURECONDITIONS FOR RUNNING
2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6
Conditions For Running
2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6SECTION Conditions For Running
WARNING: This page is about a different car, the 2003 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
This is for non scan tool Service Bay Test equipped vehicles.
- Barometric pressure is greater than 75 kPa.
- Engine coolant temperature is less than 158°F (70°C) after engine warm-up.
- Fuel level is 25-75 percent.
- Battery voltage is 10.5-16.0 volts.
- Vehicle has been driven for at least 20 minutes.
- Test will initiate only after a cold start. Engine coolant temperature is 50-95°F (10-35°C) and ECT and Intake Air Temperature (IAT) are near the same temperature.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.