SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G2500, VAN CARGO, 6.6 6REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 2684 (WIRING SYSTEMS AND POWER MANAGEMENT - A/C COMPRESSOR CLUTCH THROUGH GENERATOR X2)DOOR CONTROL MODULE - PASSENGER X3
2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6

Door Control Module - Passenger X3

2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6SECTION Door Control Module - Passenger X3
WARNING: This page is about a different car, the 2009 Cadillac STS. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Door Control Module - Passenger X3 Connector End View
GM1519691Courtesy of GENERAL MOTORS CORP.
Door Control Module - Passenger X3

Pin Wire Circuit Function
1 - - Not Used
2 0.35 D-GN/BK 787 Right Mirror Vertical Position Sensor Signal
3 0.35 L-BU/BK 785 Right Mirror Horizontal Position Sensor Signal
4 0.35 GY/BK 5861 LED Signal (UFT)
5 - - Not Used
6 0.35 RD/BK 675 Right Outside Rearview Mirror Position Sensor Low Reference
7 0.35 PU/BK 674 Right Outside Rearview Mirror Position Sensor 5-Volt Reference
8 - - Not Used
Connector Part Information 
  • OEM: 174044-2
  • Service: Service by Assembly - See Part Catalog
  • Description: 8-Way F Amp 040 Series Multi-Lock (BK)
Terminal Part Information 
  • Terminal/Tray: See Terminal Repair Kit
  • Core/Insulation Crimp: See Terminal Repair Kit
  • Release Tool/Test Probe: See Terminal Repair Kit
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.