SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G2500, VAN CARGO, 6.6 6REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 2684 (WIRING SYSTEMS AND POWER MANAGEMENT - A/C COMPRESSOR CLUTCH THROUGH GENERATOR X2)BLOWER MOTOR CONTROL MODULE X2
2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6

Blower Motor Control Module X2

2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6SECTION Blower Motor Control Module X2
WARNING: This page is about a different car, the 2009 Cadillac STS. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Blower Motor Control Module X2 Connector End View
GM1798802Courtesy of GENERAL MOTORS CORP.
Blower Motor Control Module X2

Pin Wire Circuit Function
1-2 - - Not Used
3 0.35 GY/BK 754 Blower Motor Speed Control
4 - - Not Used
5 3 BK 450 Ground
6 0.35 L-BU 188 Blower Motor Resistor Assembly Supply Voltage
Connector Part Information 
  • OEM: 7283-9749-30
  • Service: 88988512
  • Description: 6-Way F (BK)
Terminal Part Information 
  • Pin: 3
  • Terminal/Tray: 12191812/19
  • Core/Insulation Crimp: E/C
  • Release Tool/Test Probe: 15315247/J-35616-2A (GY)
  • Pin: 5
  • Terminal/Tray: 7166-4122-02/10
  • Core/Insulation Crimp: A/B
  • Release Tool/Test Probe: 12094430/J-35616-42 (RD)
  • Pin: 6
  • Terminal/Tray: 7116-4122-02/10
  • Core/Insulation Crimp: D/G
  • Release Tool/Test Probe: 12094430/J-35616-42 (RD)
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.