SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G2500, VAN CARGO, 6.6 6REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 2664 (WIRING SYSTEMS AND POWER MANAGEMENT - COMPONENT CONNECTOR END VIEWS PART 2)ELECTRONIC POWER STEERING MOTOR CONTROL MODULE X3 (HP2)
2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6

Electronic Power Steering Motor Control Module X3 (HP2)

2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6SECTION Electronic Power Steering Motor Control Module X3 (HP2)
WARNING: This page is about a different car, the 2009 GMC Sierra, 2009 GMC Cab & Chassis Sierra, 2009 Chevrolet Silverado, and 2009 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Electronic Power Steering Motor Control Module X3 (HP2) Connector End View
GM2042481Courtesy of GENERAL MOTORS CORP.
Electronic Power Steering Motor Control Module X3 (HP2)

Pin Wire Circuit Function
1 L-GN - Low Reference
2 YE - Drain Wire
3 BK - 5-Volt Reference
4 L-GN - 5-Volt Reference
5 BK - Drain Wire
6 BK - Low Reference
7 WH - Motor Resolver SIN
8 RD - Motor Resolver COS
9 WH - Low Reference
10 RD - Torque Sensor Input Shaft SIN
11 BN - Torque Sensor Input Shaft COS
12 YE - Torque Sensor Output Shaft SIN
13 BU - Torque Sensor Output Shaft COS
Connector Part Information 
  • OEM: 6189-1092
  • Service: See Catalog
  • Description: 13-Way F TS Series, Sealed (GY)
Terminal Part Information 
  • Terminal/Tray: 8100-3456/26
  • Core/Insulation Crimp: K/K
  • Release Tool/Test Probe: 15315247/J-35616-64B (L-BU)
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.