SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G2500, VAN CARGO, 6.6 6REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 2663 (WIRING SYSTEMS AND POWER MANAGEMENT - COMPONENT CONNECTOR END VIEWS PART 1)AUTOMATIC TRANSMISSION AUXILIARY FLUID PUMP CONTROL MODULE X1 (EARLY PRODUCTION WITH HP2)
2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6

Automatic Transmission Auxiliary Fluid Pump Control Module X1 (Early Production with HP2)

2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6SECTION Automatic Transmission Auxiliary Fluid Pump Control Module X1 (Early Production with HP2)
WARNING: This page is about a different car, the 2009 GMC Sierra, 2009 GMC Cab & Chassis Sierra, 2009 Chevrolet Silverado, and 2009 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Automatic Transmission Auxiliary Fluid Pump Control Module X1 (Early Production with HP2) Connector End View
GM2001240Courtesy of GENERAL MOTORS CORP.
Automatic Transmission Auxiliary Fluid Pump Control Module X1 (Early Production with HP2)

Pin Wire Circuit Function
A 5 RD/WH 4040 Battery Positive Voltage
B - - Not Available
C 5 BK 450 Ground
D 0.8 TN 982 Transmission Fluid Pump Diagnostic
E 0.5 OG 300 Ignition Voltage
F 0.8 L-GN 983 Transmission Fluid Pump Control
Connector Part Information 
  • OEM: 13599647
  • Service: See Catalog
  • Description: 5-Way M Metri-Pack 280 630 Series, Sealed (BK)
Terminal Part Information 
  • Pins: A, C
  • Terminal/Tray: 12064736/3
  • Core/Insulation Crimp: B/3
  • Release Tool/Test Probe: 12094430/J-35616-43 (RD)
  • Pins: D, F
  • Terminal/Tray: 12048159/2
  • Core/Insulation Crimp: 2/5
  • Release Tool/Test Probe: 12094430/J-35616-5 (PU)
  • Pins: E
  • Terminal/Tray: 12064734/8
  • Core/Insulation Crimp: E/3
  • Release Tool/Test Probe: 12094430/J-35616-43 (RD)
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.