SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G2500, VAN CARGO, 6.6 6REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 2651 (WIRING SYSTEMS AND POWER MANAGEMENT - COMPONENT CONNECTOR END VIEWS - ELECTRONIC COMPASS MODULE TO MEMORY SEAT MODULE (X4))COMPONENT CONNECTOR END VIEWSLIFTGATE HANDLE SWITCH (E52 OR TB7)
2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6

Liftgate Handle Switch (E52 or TB7)

2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6SECTION Liftgate Handle Switch (E52 or TB7)
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
GM697014Courtesy of
Connector Part Information
  • Harness Type: Liftgate
  • OEM Connector: 15355466
  • Service Connector: 89046633
  • Description: 2-Way M GT 150 Series Sealed (BK)
Terminal Part Information
  • Terminated Lead: 13575397
  • Release Tool: J-38125-553
  • Diagnostic Test Probe: J-35616-3 (GY)
  • Terminal/Tray: 15326269/19
  • Core/Insulation Crimp: E/4
Liftgate Handle Switch (E52 or TB7)

Pin Wire Circuit Function
A 0.35 GY 5797 Rear Closure Handle Switch Open Signal
B 0.5 BK 1450 Ground (E52 without E61)
0.35 PU/WH 5801 Low Reference (E61)
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.