Installation Procedure

2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6SECTION Installation Procedure
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Front Axle Mounting Bracket - Front Drive Axle (8.25 S4WD and 9.25 Axles)
    GM365933Courtesy of GENERAL MOTORS COMPANY
  1. Install the bracket to the vehicle.
  2. CAUTION:

    Refer to Fastener Caution .

  3. Install the washers and the nuts to the bracket and tighten to 90 N.m (67 lb ft).
  4. Install the air conditioning compressor for the 4.8 L, 5.3 L and 6.0 L engines. Refer to Air Conditioning Compressor Replacement (LY2, LY5, LH6, L76, L92, LC9 and LMG) .
  5. Install the differential carrier assembly. Refer to Differential Carrier Assembly Replacement (9.25 inch)Β .
  6. Lower the vehicle.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.