Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G2500, VAN CARGO, 6.6 6REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 259 (BUMPER SYSTEM)SPECIFICATIONS
2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6
Section 259 (Bumper System): Specifications
2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6SECTION Specifications
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2003 GMC Savana Special, 2003 GMC Savana Camper Special, 2003 GMC Savana, 2003 Chevrolet RV Cutaway, and 2003 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
Fastener Tightening Specifications
| Application | Specification | |
|---|---|---|
| Metric | English | |
| Front Air Deflector to Bumper Bolts | 3 N.m | 27 lb in |
| Front Bumper Impact Bar Bracket to Bumper and Bumper Reinforcement Bolts | 25 N.m | 18 lb ft |
| Front Bumper Impact Bar Bracket to Frame Bolts | 50 N.m | 37 lb ft |
| Front Bumper Impact Bar to Bumper Bolts | 25 N.m | 18 lb ft |
| Front Bumper Step Pad Extension Nuts | 1.5 N.m | 13 lb in |
| Front License Plate Bracket to Bumper Bolts | 3 N.m | 27 lb in |
| Front License Plate Filler Screws | 2.2 N.m | 19.5 lb in |
| Rear Bumper Impact Bar Inner Brace to Bumper Bolts | 25 N.m | 18 lb ft |
| Rear Bumper Impact Bar Inner Brace to Frame Nuts | 50 N.m | 37 lb ft |
| Rear Bumper Impact Bar Outer Brace to Bumper Nuts and Bolts | 50 N.m | 37 lb ft |
| Rear Bumper Impact Bar Outer Brace to Frame Nuts | 50 N.m | 37 lb ft |
| Rear Bumper Step Pad Extension Nuts | 1.5 N.m | 13 lb in |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.