Steering Wheel Heat Control Module Replacement

2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6SECTION Steering Wheel Heat Control Module Replacement
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: View Of Steering Wheel Heat Module & Screws
GM1728559Courtesy of GENERAL MOTORS COMPANY
Steering Wheel Heat Control Module Replacement

Callout Component Name
Preliminary Procedure 
Remove the horn switch. Refer to Steering Wheel Horn Switch Replacement .
1 Steering Wheel Heat Module Screw (Qty: 5)
CAUTION:

Refer to Fastener Caution .


Tighten 
2 N.m (18 lb in)
2 Steering Wheel Heat Module
Procedure 
Disconnect any electrical connectors as needed.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.