Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G2500, VAN CARGO, 6.6 6REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 2552 (CELLULAR SYSTEM, ENTERTAINMENT SYSTEM, AND NAVIGATION SYSTEM)DIAGNOSTIC INFORMATION AND PROCEDURESAUDIO/VIDEO PLAYER ADAPTER - AUDIO OR VIDEO MALFUNCTIONCIRCUIT/SYSTEM TESTING
2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6
Circuit/System Testing
2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6SECTION Circuit/System Testing
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
Verify the DVD player in the radio is operating normally before performing this diagnostic procedure. If there is any problems with operating the DVD player, refer to Symptoms - Entertainment
- Ignition OFF, disconnect the X3 harness connector at the radio.
- Ignition ON, test for less then 1 volt between the appropriate signal circuit terminals listed below and ground.
- Auxiliary audio left signal (+) - terminal 1
- Auxiliary audio right signal (+) - terminal 2
- Auxiliary audio drain wire (-) - terminal 9
- Auxiliary video signal (+) - terminal 8
- Auxiliary video drain wire (+) - terminal 16
- If greater then specified range, test the circuit for a short to voltage.
- Test for infinite resistance between the terminals listed below and ground.
- Auxiliary audio left signal (+) - terminal 1
- Auxiliary audio right signal (+) - terminal 2
- Auxiliary audio drain wire (-) - terminal 9
- Auxiliary video signal (+) - terminal 8
- Auxiliary video drain wire (+) - terminal 16
- If less then the specified value, test the circuit for a short to ground.
- Test for less then 5 ohm between the terminals on the radio X3 harness connector and the external terminals on the audio/video adaptor listed below:
- Auxiliary audio left signal (+) - terminal 1 and the inside of the center (white) jack
- Auxiliary audio right signal (+) - terminal 2 and the inside of the right (red) jack
- Auxiliary audio drain wire (-) - terminal 9 and the outside of both the center (white), and the right (red) jacks
- Auxiliary video signal (+) - terminal 8 and the inside of the left (yellow) jack
- Auxiliary video drain wire (+) - terminal 16 and the outside of the left (yellow) jack
- If greater then the specified value, test the circuit for an open/high resistance. If the circuit tests normal, replace the adaptor.
- If all circuits test normal, replace the radio.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.