Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G2500, VAN CARGO, 6.6 6REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 2547 (INSTRUMENT PANEL TRIM AND CONSOLE TRIM)REPAIR INSTRUCTIONSFRONT FLOOR CONSOLE ARMREST REPLACEMENT
2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6
Front Floor Console Armrest Replacement
2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6SECTION Front Floor Console Armrest Replacement
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Front Floor Console Armrest Replacement
| Callout | Component Name |
|---|---|
| 1 | Front Floor Console Compartment Cover Assembly |
| 2 | Front Floor Console Armrest Assembly Screw (Qty: 3)
CAUTION:
Refer to Fastener Caution . Tighten 2 N.m (18 lb in) |
| 3 | Front Floor Console Armrest Assembly TIP: When replacing the front floor console armrest, inspect the old front floor console armrest hinge assembly for proper operation. If the old hinge assembly is operational and functioning properly, remove and discard the hinge assembly from the new part and use remaining parts of the armrest for replacement, leaving the old hinge in place. |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.