SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G2500, VAN CARGO, 6.6 6REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 2516 (WIRING SYSTEMS AND POWER MANAGEMENT - COMPONENT CONNECTOR END VIEWS - ELECTRONIC STEERING CONTROL MODULE X2 THROUGH MEMORY SEAT MODULE)COMPONENT CONNECTOR END VIEWSENGINE OIL PRESSURE (EOP) SENSOR
2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6

Engine Oil Pressure (EOP) Sensor

2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6SECTION Engine Oil Pressure (EOP) Sensor
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Engine Oil Pressure (EOP) Sensor Connector End View
GM2159957Courtesy of GENERAL MOTORS CORP.
Engine Oil Pressure (EOP) Sensor

Pin Wire Circuit Function
1 0.5 TN/WH 331 Oil Pressure Sensor Signal
2 0.5 GY 2705 5-Volt Reference
3 0.5 BK 2755 Low Reference
Connector Part Information
  • Harness Type: Engine
  • OEM Connector: 13589761
  • Service Connector: 13501882
  • Description: 3-Way F GT 150 Series, Sealed (BK)
Terminal Part Information
  • Terminated Lead: 13575413
  • Release Tool: J-38125-553
  • Diagnostic Test Probe: J-35616-2A (GY)
  • Terminal/Tray: 12191819/8
  • Core/Insulation Crimp: E/1
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.