SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2008CHEVY EXPRESS G2500, VAN CARGO, 6.6 6REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 2452 (HVAC SYSTEM - AUTOMATIC)REPAIR INSTRUCTIONSAUXILIARY INSIDE AIR TEMPERATURE SENSOR ASSEMBLY REPLACEMENTREMOVAL PROCEDURE
2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6

Removal Procedure

2008 Chevrolet Chevy Express G2500, Van Cargo, 6.6 6SECTION Removal Procedure
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the third pillar molding. Refer to Center Pillar Upper Garnish Molding Replacement .
  2. Remove the left rear coat hook, if equipped. Refer to Coat Hook Replacement .
  3. Remove the rear headliner retainers from the front headliner.
  4. Carefully lower the headliner from the roof hook and loop retainers.
    5. Fig 1: Electrical Connector & Inside Air Temperature Sensor
    GM675996Courtesy of GENERAL MOTORS CORP.
  5. Disconnect the electrical connector from the inside air temperature sensor.
    6. Fig 2: Inside Air Temperature Sensor
    GM675994Courtesy of GENERAL MOTORS CORP.
  6. Partially remove the auxiliary inside air temperature sensor from the headliner.
  7. Remove the sensor grille from the auxiliary inside air temperature sensor.
  8. Remove the auxiliary inside air temperature sensor from the headliner.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.